The vertical forward-fixed point and the vertical rearward-fixed point can be determined by manipulator. It helps to speed up the yield of finished products.
This machine can be single acting or fully automatically acting when wire-linked with die-casting machine and extracting machine.
This machine is installed with more than two atomizers of SS s own. The effect of atomization is prominent when it is applied to thin castings. It improves the effect of atomization on both movable and stationary molds.
The time for spraying release agent on to stationary mold flank and movable mold flank can be adjusted to meet the requirements of different products.
This machine can carry out blowing operation when ascending, that is it can ascend and clean up the surface of the stationary and movable mold synchronously after spraying.
This machine can regulate the spraying dosage of release agent.
The speed of ascending and descending is stable. It can slowdown the descending speed and regulate the speed of buffer, extending the longevity of buffer. The velocity of buffer is adjustable. A falling avoidance device prevents the spraying nozzle from falling when the wind pressure source suspends functioning.
The central spraying function can be installed and two different release agents can be used to improve the release effect if required by clients.
This machine adopts PLC control loop and can display failure codes, facilitating the maintenance.
The vertical forward-fixed point and the vertical rearward-fixed point can be determined by
|Specification/ model ||SSAS- 1 ||SSAS- 2 ||SSAS- 3 |
|Suitable die- casting machine ||80T/120T/160T ||250T/400T ||670mm (14 pcs) |
|Copper pipe (fixed mold) ||19 pcs (dia 6) ||21 pcs (dia 8) ||24 pcs (dia 8) |
|Copper pipe (midst)||18 pcs (dia 6)||20 pcs (dia 8) ||23 pcs (dia 8) |
|Copper pipe (movable mold) ||19 pcs (dia 6)||21 (pcs dia 6) ||24 pcs (dia 8) |
|Wind pressure source ||4.5-6.5kgf/cm2 |
|Interface of wind pressure source ||PT1 ||PT11/2 |
|Release agent ||2 5-6kgf/cm |
|Release agent interface ||PT1/2 |
|Adjustable thickness of mold || Ã‚Â±150mm |
|Ascending time ||1.0s||1.2s ||2.0s|
|Descending time ||1.2s ||1.2s ||2.0s |
|Number of atomizer ||2 ||3 |
|Length of atomizing nozzle ||350mm ||420mm ||480mm |
|Length of copper pipe- long ||570mm (14 pcs) ||570mm (14 pcs) ||570mm (57 pcs) |
|Length of copper pipe- short ||470mm (42pcs) ||470mm (48pcs) ||670mm (14 pcs) |
|Power supply ||(Uniphase) 220V 50-60Hz |
|Spraying time for release agent ||max 9.9 & max 9.9 Fixed mold 9.9secs. (Max) & Movable mold 9.9secs. (Max.) |
|Water volume for release agent ||(Water volume for fixed and movable mold is adjustable) |
|Center distance ||(Center distance between fixed mold and atomizing nozzle is) 110mmÃ‚Â±20mm |
|Weigth of machine ||400kg ||420kg ||560kg |